RDM EC7000i Guide d'installation télécharger pdf (Page 18)

Status Signals for EC6000i and EC7000i

The scanner comes equipped with the default light and sound signals described below.

EC6000i/EC7000i Default Light Signals

The unit’s status is shown through a single, multi-state LED (light-emitting diode), which is the light on the

top, front, right-hand side of the unit. The table below describes typical status signals and their meanings.

LED Meaning; What To Do

Green Solid The unit is ready to accept a check; insert a check.

Green Flashing The unit is busy, processing the last check; wait for the job to finish.

Amber Solid The unit is idle; start the next job with a command from the terminal or PC

application.

Amber Flashing The unit is sending or receiving information from the terminal or PC

application; wait.

Red / Green / Amber Flashing The unit is starting up or performing diagnostics; wait.

Red Solid The unit failed during a self-test; check the terminal display for instructions /

refer to your local procedures / call you distributor (reseller).

Red Flashing An error occurred during processing. See “Default Sound Signals” on the

next page for details; check the terminal display for instructions / refer to your

local procedures / call your distributor (reseller).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Pas de commentaire

RDM EC7000i Guide d'installation Page 18